| Commit message (Collapse) | Author | Age |
|---|
| ... | |
| |
|
|
|
|
| |
Before, some places didn't document the short options (-? and -V),
some documented both, some documented nothing, and they were listed in
various orders. Now this is hopefully more consistent and complete.
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Formerly, if the system clock went backwards, the stats collector would
fail to update the stats file any more until the clock reading again
exceeds whatever timestamp was last written into the stats file. Such
glitches in the clock's behavior are not terribly unlikely on machines
not using NTP. Such a scenario has been observed to cause regression test
failures in the buildfarm, and it could have bad effects on the behavior
of autovacuum, so it seems prudent to install some defenses.
We could directly detect the clock going backwards by adding
GetCurrentTimestamp calls in the stats collector's main loop, but that
would hurt performance on platforms where GetCurrentTimestamp is expensive.
To minimize the performance hit in normal cases, adopt a more complicated
scheme wherein backends check for clock skew when reading the stats file,
and if they see it, signal the stats collector by sending an extra stats
inquiry message. The stats collector does an extra GetCurrentTimestamp
only when it receives an inquiry with an apparently out-of-order
timestamp.
To avoid unnecessary GetCurrentTimestamp calls, expand the inquiry messages
to carry the backend's current clock reading as well as its stats cutoff
time. The latter, being intentionally slightly in-the-past, would trigger
more clock rechecks than we need if it were used for this purpose.
We might want to backpatch this change at some point, but let's let it
shake out in the buildfarm for awhile first.
|
| |
|
|
|
|
|
| |
Since this is the easy way of doing it, it should be listed first. All
the old information is retained for those who want the more advanced way.
Also adds a subheading for compressing logs, that seems to have been missing
|
| |
|
|
|
|
| |
Backpatch to 9.2.
Per suggestion from Noah Misch
|
| | |
|
| |
|
|
|
|
| |
Àlvaro and Noah Misch.
Backpatch to 9.2.
|
| |
|
|
|
|
|
|
| |
connection failure.
Backpatch to 9.2.
Per report from Evan D. Hoffman
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
Because permissions are assigned to element types, not array types,
complaining about permission denied on an array type would be
misleading to users. So adjust the reporting to refer to the element
type instead.
In order not to duplicate the required logic in two dozen places,
refactor the permission denied reporting for types a bit.
pointed out by Yeb Havinga during the review of the type privilege
feature
|
| |
|
|
|
| |
Even though we can't do much about the case with multiple plurals in
one sentence, we can fix the other cases.
|
| |
|
|
| |
Gurjeet Singh, with corrections by me.
|
| |
|
|
| |
Fujii Masao
|
| |
|
|
|
| |
Darold Gilles, reviewed by Gabriele Bartolini and others, rebased by
Marco Nenciarini. Stylistic cleanup and OID fixes by me.
|
| |
|
|
|
|
|
|
| |
There's no need to hold onto the locks until the files are needed,
and by doing it this way, we reduce the impact on other backends who
may be awaiting locks we hold.
Noah Misch
|
| |
|
|
|
|
|
|
| |
When I implemented the ginbuildempty() function as part of
implementing unlogged tables, I falsified the note in the header
comment for log_newpage. Although we could fix that up by changing
the comment, it seems cleaner to add a new function which is
specifically intended to handle this case. So do that.
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
Even when allow_system_table_mods is not set, we allow creation of any
type of SQL object in pg_catalog, except for relations. And you can
get relations into pg_catalog, too, by initially creating them in some
other schema and then moving them with ALTER .. SET SCHEMA. So this
restriction, which prevents relations (only) from being created in
pg_catalog directly, is fairly pointless. If we need a safety mechanism
for this, it should be placed further upstream, so that it affects all
SQL objects uniformly, and picks up both CREATE and SET SCHEMA.
For now, just rip it out, per discussion with Tom Lane.
|
| |
|
|
|
|
|
| |
This may have been important at some point in the past, but it no
longer does anything useful.
Review by Tom Lane.
|
| |
|
|
| |
Alastair Turner, per suggestion from Bruce Momjian.
|
| | |
|
| |
|
|
| |
We have this info in the wiki, but it should be here too.
|
| |
|
|
|
|
| |
This includes fixing the MSVC copy of ecpg/preproc's version info, which
seems to have been overlooked repeatedly. Can't we fix that so there are
not two copies??
|
| |
|
|
| |
Let the hacking begin ...
|
| |
|
|
|
|
|
|
|
| |
Instead of identifying error locations only by line number (which could
be entirely unhelpful with long input lines), provide a fragment of the
input text too, placing this info in a new CONTEXT entry. Make the
error detail messages conform more closely to style guidelines, fix
failure to expose some of them for translation, ensure compiler can
check formats against supplied parameters.
|
| | |
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
This reverts commit 18fb9d8d21a28caddb72c7ffbdd7b96d52ff9724. Per
discussion, it does not seem like a good idea to allow committed changes to
go un-checkpointed indefinitely, as could happen in a low-traffic server;
that makes us entirely reliant on the WAL stream with no redundancy that
might aid data recovery in case of disk failure.
This re-introduces the original problem of hot-standby setups generating a
small continuing stream of WAL traffic even when idle, but there are other
ways to address that without compromising crash recovery, so we'll revisit
that issue in a future release cycle.
|
| |
|
|
| |
I had this slightly wrong, as noted by Noah Misch.
|
| |
|
|
|
|
|
|
|
|
|
|
|
| |
Aside from adjusting the documentation to say that these are deprecated,
we now report a warning (not an error) for use of GLOBAL, since it seems
fairly likely that we might change that to request SQL-spec-compliant temp
table behavior in the foreseeable future. Although our handling of LOCAL
is equally nonstandard, there is no evident interest in ever implementing
SQL modules, and furthermore some other products interpret LOCAL as
behaving the same way we do. So no expectation of change and no warning
for LOCAL; but it still seems a good idea to deprecate writing it.
Noah Misch
|
| |
|
|
|
|
|
|
|
| |
The simplest way to handle this is just to copy-and-paste the relevant
code block in fork_process.c, so that's what I did. (It's possible that
something more complicated would be useful to packagers who want to work
with either the old or the new API; but at this point the number of such
people is rapidly approaching zero, so let's just get the minimal thing
done.) Update relevant documentation as well.
|
| |
|
|
|
|
| |
clusters, and make sure the new cluster has no additional users.
Backpatch to 9.1.
|
| |
|
|
|
|
| |
Clarify help (s/return/print/), and explain that this option is for
use by other programs, not for user-facing use (it does not print
units).
|
| |
|
|
|
| |
Improve commenting, conform to project style for use of ++ etc.
No functional changes.
|
| |
|
|
| |
Per gripe from Tom Lane.
|
| |
|
|
|
|
|
| |
Remove a couple of items that were actually back-patched bug fixes.
Add additional details to a couple of items which lacked a description.
Improve attributions for a couple of items I was involved with.
A few other miscellaneous corrections.
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
| |
Commit aaa6e1def292cdacb6b27088898793b1b879fedf introduced multiple hazards
in the case where pg_ctl is executed with neither a -D switch nor any
PGDATA environment variable. It would dump core on machines which are
unforgiving about printf("%s", NULL), or failing that possibly give a
rather unhelpful complaint about being unable to execute "postgres -C",
rather than the logically prior complaint about not being told where the
data directory is.
Edmund Horner's report suggests that there is another, Windows-specific
hazard here, but I'm not the person to fix that; it would in any case only
be significant when trying to use a config-only PGDATA pointer.
|
| |
|
|
|
|
|
|
| |
"pg_dump -Ft -f filename ..." got broken by my recent commit
4317e0246c645f60c39e6572644cff1cb03b4c65, which I fear I only tested
in the output-to-stdout variant.
Report and fix by Muhammad Asif Naeem.
|
| |
|
|
|
|
|
|
| |
getopt_long() allows abbreviating long options, so we might as well
give the option the full name, and users can abbreviate it how they
like.
Do some general polishing of the --help output at the same time.
|
| |
|
|
|
|
|
|
|
|
|
|
| |
This prevents a pg_basebackup backup session that just does a base
backup (no xlog involved at all) from becoming the synchronous slave
and thus blocking all access while it runs.
Also fixes the problem when a higher priority slave shows up it would
become the sync standby before it has reached the STREAMING state, by
making sure we can only switch to a walsender that's actually STREAMING.
Fujii Masao
|
| |
|
|
|
|
|
|
| |
To replace it, add -X/--xlog-method that allows the specification
of fetch or stream.
Do this to avoid unnecessary backwards-incompatiblity. Spotted and
suggested by Peter Eisentraut.
|
| |
|
|
| |
commit-fest.
|
| | |
|
| |
|
|
|
|
|
| |
Since the replication protocol deals with TimestampTz, we need to
care for the floating point case as well in the frontend tools.
Fujii Masao, with changes from Magnus Hagander
|
| | |
|
| | |
|
| | |
|
| | |
|
| |
|
|
|
|
|
|
|
|
| |
When HS startup is deferred because of overflowed subtransactions, ensure
that we re-initialize KnownAssignedXids for when both existing and incoming
snapshots have non-zero qualifying xids.
Fixes bug #6661 reported by Valentine Gogichashvili.
Analysis and fix by Andres Freund
|
| |
|
|
| |
Dan Farina
|
| | |
|
| |
|
|
|
|
|
|
| |
This provides a speedup of about 4X when NBuffers is large enough.
There is also a useful reduction in sinval traffic, since we
only do CacheInvalidateSmgr() once not once per fork.
Simon Riggs, reviewed and somewhat revised by Tom Lane
|
| | |
|
| | |
|
