pg_archivecleanup pg_archivecleanup is designed to cleanup an archive when used as an archive_cleanup_command when running with standby_mode = on. pg_archivecleanup can also be used as a standalone program to clean WAL file archives. pg_archivecleanup features include: Written in C, so very portable and easy to install Easy-to-modify source code, with specifically designated sections to modify for your own needs To configure a standby server to use pg_archivecleanup, put this into its recovery.conf configuration file: archive_cleanup_command = 'pg_archivecleanup archiveDir %r' where archiveDir is the directory from which WAL segment files should be restored. When used within archive_cleanup_command, all WAL files logically preceding the value of the %r will be removed archivelocation. This minimizes the number of files that need to be retained, while preserving crash-restart capability. Use of this parameter is appropriate if the archivelocation is a transient staging area for this particular standby server, but not when the archivelocation is intended as a long-term WAL archive area. The full syntax of pg_archivecleanup's command line is pg_archivecleanup option ... archivelocation restartwalfile When used as a standalone program all WAL files logically preceding the restartwalfile will be removed archivelocation. In this mode, if you specify a .backup file name, then only the file prefix will be used as the restartwalfile. This allows you to remove all WAL files archived prior to a specific base backup without error. For example, the following example will remove all files older than WAL file name 000000010000003700000010: pg_archivecleanup -d archive 000000010000003700000010.00000020.backup pg_archivecleanup: keep WAL files 000000010000003700000010 and later pg_archivecleanup: removing "archive/00000001000000370000000F" pg_archivecleanup: removing "archive/00000001000000370000000E" pg_archivecleanup assumes that archivelocation is a directory readable and writable by the server-owning user. pg_archivecleanup accepts the following command-line arguments: -d Print lots of debug logging output on stderr. On Linux or Unix systems, you might use: archive_cleanup_command = 'pg_archivecleanup -d /mnt/standby/archive %r 2>>cleanup.log' where the archive directory is physically located on the standby server, so that the archive_command is accessing it across NFS, but the files are local to the standby. This will: produce debugging output in cleanup.log remove no-longer-needed files from the archive directory pg_archivecleanup is designed to work with PostgreSQL 8.0 and later when used as a standalone utility, or with PostgreSQL 9.0 and later when used as an archive cleanup command. Simon Riggs simon@2ndquadrant.com